Woodworking Tooling

Design Z3/V3, GL = 57 mm. For high feeds compared to Z2/V2. Design without projecting centre-point. For boring workpieces near the bottom surface layer without marking or piercing the surface. Not suitable for solid wood.

Dowel pins are often used as precise locating devices in machinery. Steel dowel pins are machined to tight tolerances, as are the corresponding holes, which are typically reamed. A dowel pin may have a smaller diameter than its hole so that it freely slips in, or a larger diameter so that it must be pressed into its hole.

finger joint cutters are the ultimate in quality and cutting precision. Our finger joint cutters are manufactured using American Iron and Steel Institute (AISI) rolled and billet stock M2 tool steel, hardened and ground to specific dimensional tolerances of ±. 0001 of an inch (.0025 mm).

TCT Carbide Tipped Knives offer over 1,000% (10 times) the tool life of T1-HSS. Carbide is used on hardwoods (i.e. Hickory, Hard Maple, MDF, plywood, etc.) Carbide is very hard (~92 Rc) and should be sharpened using a diamond wheel or silicon carbide type grinding wheel (call if you need these grinding wheels).

Some milling cutters can drill straight down (plunge) through the material, while others cannot. This is because the teeth of some cutters do not go all the way to the centre of the end face. However, these cutters can cut downwards at an angle of 45 degrees or so.

A corner chisel is a tool for cutting sharp internal corners in wood, often used for mortice joints, or hinge rebates. The hole will typically be cut by a router, or occasional drilled, leaving rounded corners, the function of the corner chisel is therefore similar to the square morticing chisel used on a morticing machine.

Stainless steel and Aluminum handles are durable and sanitary, but can be slippery. To counter this, premium knife makers make handles with ridges, bumps, or indentations to provide extra grip. Another problem with knives that have metal handles is that, since metal is an excellent heat-conductor, these knives can be very uncomfortable,

To retract the blade back into the handle, a release lever or button, usually the same control as to open, is pressed. A very common form of sliding knife is the sliding utility knife (commonly known as a stanley knife or boxcutter).

We offer the HSS Planer Knife and blades at any price. We
specialize though in offering wholesale prices direct to your work shop.
Thousands of sets of premium blades and inserts are in stock for immediate shipment in Carbide, HSS, and other specialty alloys.

Wood moulders almost always have the capacity to serve as a wood planer as well. For this reason they are also known as Planer/ Moulders.[citation needed] However, a wood planer does not necessarily have the capability to be a moulder. There are several makes and models of both planers and planer/ moulders on the market.

our company is specialized in producing Makita Planer Blade--disintegrator blades and other cutting blades;we are one of the main woodworking blade manufacturers in china and stay in the front of industry with good quality and big production capacity!

The Reversible Carbide Planer Blade is designed for use with the DeWalt DW675K planer. Factory sharpened for superior performance and extended life, this blade is sharpened on both sides for greater efficiency. And since the Reversible Carbide Planer Blade is reversible, it's like you always have a spare blade handy.